3.7. Removal of a natyazhitel of a chain of the drive of the camshaft

Key "on 10" we turn off two nuts of fastening of a natyazhitel to a head of the block of cylinders.

We take out a natyazhitel...

... also we remove its sealing laying.

Having clamped a natyazhitel in a vice, a key "on 13" we turn off the cap-type nut.

We remove the cap-type nut and we check serviceability of the collet clip located in it.

At breakage at least of one of pads of a clip we change the cap-type nut or a natyazhitel assembled.

Before installation of a natyazhitel utaplivay a plunger in the case of a natyazhitel against the stop and, holding a plunger in such situation...

... we tighten the cap-type nut.

We apply sealant on new laying and we establish a natyazhitel in the return sequence. We regulate a chain tension (see. "Adjustment of a tension of a chain of the drive of the camshaft").