3.19. Removal of support of the power unit on the car with the VAZ-2106 engine

We perform work on a viewing ditch or the elevator.

Cap key "on 13" we turn off nuts of two bolts of fastening of a pillow of the left forward support of the power unit to a stretcher arm, holding bolts from a provorachivaniye a cap key "on 12".

We take out bolts.

Similarly we turn off...

... also we take out two bolts of fastening of a pillow of the left forward support of the power unit to an arm of the block of cylinders of the engine.

We establish an adjustable support under the left edge of the pallet of a case and, raising the power unit a little...

... we take out a pillow of the left forward support.

In the same way we disconnect fastenings and we take out a pillow of the right forward support of the power unit. In this case we establish an adjustable emphasis under the right edge of the pallet of a case. Operations on dismantle of a pillow of a back support of the power unit are similar to operations on the car with the engine UEPA-331 and are shown in the subsection "Removal of Support of the Power Unit on the Car with the Engine UEPA-331".

For removal of a cross-piece of a back support assembled we substitute an adjustable emphasis under the lower cover of a case of the transmission.

Cap key "on 14" we turn off two bolts of fastening of a cross-piece of a back support to body arms.

Head "on 13" we turn off two nuts of hairpins of fastening of an arm of a cross-piece of a back support to a back cover of the transmission.

We remove a cross-piece assembled with a pillow and an arm.

Head "on 12" we turn off two bolts of fastening of a pillow to an arm...

... also we remove an arm.

If on pillows of support of the power unit there are cracks, gaps or peelings of rubber, replace them new and we establish in the return sequence.