19.9.3. Removal and dismantling of a starter 421.3708

We disconnect a wire of "weight" from the rechargeable battery.

We disconnect a wire of management from the traction relay.

Having shifted a rubber protective cap...

... a key "on 13" we turn off a nut of fastening of a "plus" wire (from the rechargeable battery) and we remove its tip from a hairpin of the traction relay.

Key "on 17" we turn off two nuts of fastening of a starter...

... also we remove a starter from coupling case hairpins.

Key "on 13" we turn off a nut of fastening of a power wire to the traction relay

We unscrew three screws of fastening of the traction relay.

We remove the case of the traction relay...

... also we take out a relay anchor.

We unscrew two screws of fastening of a cap.

We take off a cap and its laying.

We remove a lock washer of a shaft of an anchor.

Key "on 10" we turn off two nuts...

... also we remove a back cover.

We shift the case from hairpins.

Key "on 10" we turn off a lever axis nut, holding an axis from a provorachivaniye the screw-driver.

We take out an axis.

We take out an anchor from a forward cover and we remove the drive lever.

Operev an anchor shaft on wooden whetstone, through a key "on 14" we force down a restrictive ring.

We hook the screw-driver and we remove a lock ring.

We remove from an anchor a restrictive ring, the drive assembled and the bearing assembled.

We check serviceability of a starter similar to check of a starter 35.3708 (see. "Removal and dismantling of a starter 35.3708").

We collect and establish a starter in the return sequence. We grease screw vents of a shaft of an anchor and a nave of the coupling, a flood ring and an axis of the lever with a thin layer of Litol-24 lubricant, and bearings and necks of a shaft of an anchor — engine oil.