Пенополистирол купить в спб на сайте www.sever-m.ru.

19.8.6. Removal and dismantling of the generator 37.3701

We disconnect a wire of "weight" from the rechargeable battery.

We disconnect a wire tip from tension regulator conclusion (a conclusion "61").

We shift a protective rubber cover from a conclusion "30" generators...

... a key "on 10" we turn off a nut of fastening of wires to a conclusion "30"...

... also we remove tips of wires from a conclusion "30".

Cap key "on 17" we turn off...

... a nut of fastening of the generator to an adjusting level...

... and a nut of fastening of a level to a hairpin of a cover of the pump of cooling liquid (see. "Removal of a cover assembled the pump of cooling liquid on the car with the VAZ-2106 engine").

We remove an adjusting level.

Cap key "on 19" we turn off a nut of a bolt of the lower fastening of the generator.

Holding the generator, we take a bolt...

... also we take out the generator from a motor compartment.

In an eye of a back cover of the generator plugs are installed two metal and one rubber (buffer).

We disconnect a wire from tension regulator.

By the crosswise screw-driver it is turned off two screws of fastening of the regulator of tension and brush knot.

We remove tension regulator with brush knot.

Key "on 19" we turn off a generator pulley nut. The rotor from a provorachivaniye can be stopped the screw-driver (do not bend a krylchatka). We remove a washer from a shaft...

... pulley halves...

... expansion washer...

... and krylchatka.

We hook the screw-driver and we remove a segment spline...

... behind which the washer without shponochny groove is located.

Key "on 10" we turn off a nut of fastening of a tip of a wire of the condenser.

We remove a condenser wire tip.

Having unscrewed the crosswise screw-driver the screw of fastening of the condenser, we remove the condenser. With sharply ground chertilka or paint it is marked a relative positioning of covers and the stator for the subsequent assembly.

Head "on 10" we turn off four nuts of coupling bolts.

We take out bolts.

We remove a forward cover.

For replacement of the bearing with a key "on 8" from the outer side of a cover we turn off four nuts of screws of fastening of plates.

We remove plates with screws.

Tool head of the suitable size (or a pipe piece) we press off the bearing from a cover.

On a shaft of a rotor the persistent ring is located.

Navorachivayem on a shaft carving a nut, we clamp it in a vice and by breakthrough it is removed a back cover with the stator.

At difficulty in removal of a rotor we tap on its end face with a drift from soft metal through tension regulator window.

We separate a rotor and the stator.

Stripper we press the bearing from a rotor shaft.

Head "on 8" we turn off three nuts of fastening of conclusions of windings of the stator to the vypryamitelny block.

Having hooked the screw-driver...

... we remove the stator.

We remove the vypryamitelny block.

We take out a contact bolt from the vypryamitelny block.

We collect and install the generator on the car in the return sequence.