12.6. Removal of the transmission

Work is carried out on a viewing ditch or the elevator.

We disconnect a wire of "weight" from the rechargeable battery.

We disconnect wires from the switch of lamps of a backing (see. "Replacement of the switch of lamps of a backing").

On the car with a mechanical speedometer the flexible shaft is disconnected from a reducer of its drive (see. "Removal of a flexible shaft of the drive of a speedometer"). If the car is completed with a combination of devices with an electronic spidemetr, then we disconnect the speed sensor plug (see. "Removal of the drive of a speedometer").

We turn off two bolts of fastening of the working cylinder of coupling to a coupling case (see. "Removal of the working cylinder of a hydraulic actuator of coupling on the car with the VAZ-2106 engine") also we take away the cylinder forward, without separating a hydraulic actuator.

We remove a floor casing (see. "Removal of a casing of a floor") and an air supply air duct in a back part of salon (see. "Removal of an air duct of air supply in a back part of salon").

We remove a protective cover of the drive of gear shifting and a core of the lever of gear shifting (see. "Removal and installation of the transmission on the car with the engine UEPA-331", a photo 1-3 and 10-11).

We turn off bolts of fastening of a starter to a coupling case (see. "Removal and dismantling of a starter 35.3708").

We remove cardan transfer (see. "Removal of cardan transfer").

Key "on 10" we turn off four bolts of fastening of a cover of a case of coupling.

We disconnect an arm of a reception pipe from the arm fixed on a transmission case (see. "Removal of a reception pipe on the car with the VAZ-2106 engine").

We substitute under a transmission case an adjustable emphasis (or a jack).

Cap key "on 14" we turn off two bolts of fastening of a cross-piece of a back support of the power unit to floor arms.

By head "on 19" with the cardan hinge and the extender it is turned off four bolts of fastening of a case of coupling to the block of cylinders of the engine.

Accurately we shift the transmission together with a coupling case back, bringing its main shaft out of a nave of the conducted clutch plate...

... also we remove the transmission.

At removal and installation of the transmission it is impossible to opirat a main shaft of a box on petals of a press spring of coupling that not to damage them.

We install the transmission in the return sequence. Before installation the end of a main shaft is applied a thin film of SHRUS-4 lubricant on shlitsevy. After installation of a box we regulate a free wheeling of a pusher of a fork of switching off of coupling (see. "Adjustment of the drive of switching off of coupling").