10.7. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the VAZ-2106 engine

We perform work on a viewing ditch or the elevator.

We remove a returnable spring.

Passatizhami we take out the forelock from an opening in a pusher.

Cap key "on 13" we turn off two bolts of fastening of the working cylinder to a coupling case.

We take out bolts and we remove an arm of a returnable spring.

We bring a pusher out of a coupling switching off fork opening.

Holding a tip of a flexible hose from a provorachivaniye a key "on 17", we rotate the cylinder for an adapter hexagon a key of the same dimension...

... also we remove the cylinder.

Connection of a hose with an adapter is condensed with copper laying.

Holding the cylinder for a case stopper a key "on 22", we turn off an adapter a key "on 17"...

... also we separate the cylinder from an adapter.

We install the working cylinder in the return sequence. If at the same time the flexible hose of a hydraulic actuator was strongly overwound, we weaken connection of a hose with a metal tube of a hydraulic actuator and an eye of a body (see. "Removal of a flexible hose of a hydraulic actuator of coupling"), we turn a hose in the necessary situation and again we delay connections. We pump over a coupling hydraulic actuator (see. "Pumping of a hydraulic actuator of coupling").