10.6. Removal of the working cylinder of a hydraulic actuator of coupling on the car with the engine UEPA-331

We perform work on a viewing ditch or the elevator.

We remove an ottyazhny spring (see. "Adjustment of the drive of switching off of coupling").

Having hooked the screw-driver, we shift a protective cap from a cylinder corbel.

By nippers it is unclenched a lock ring of the cylinder...

... also we remove it.

We bring the cylinder out of a coupling case eye.

For replacement of a pusher of a fork or a protective cap of the cylinder...

... we remove a pusher.

Holding a hose tip a key "on 17" and rotating the cylinder for an adapter hexagon a key of the same dimension, we unscrew the cylinder...

... also we remove it (connection is condensed with a copper ring).

Holding the cylinder case a pipe key, we turn off an adapter a key "on 17".

Connection is condensed with aluminum laying.

We install the working cylinder in the return sequence. If at the same time the flexible hose of a hydraulic actuator was strongly overwound, we weaken connections of the top tip of a hose with a metal tube of a hydraulic actuator and an eye of a body (see. "Removal of a flexible hose of a hydraulic actuator of coupling"), we turn a hose in the necessary situation and again we delay connections. We pump over a coupling hydraulic actuator (see. "Pumping of a hydraulic actuator of coupling").